Wednesday, September 3, 2014

DIY Fabric Hair Bow |
-Fabric (6x4, or of your choosing)
-Needle & Thread
-Bobby Pin


1. I used a piece of fabric cut into an 8 x 6 rectangle for the bow tie and 6 x 4 for the bow. You can experiment to see which size works best for you. Then fold in the pieces of fabric as seen in the first image below.

2. Then fold the other ends in so they meet again. (The scissors are just holding them down so I could snap the picture)

3. After it has been folded go ahead and turn it over and pinch down the center of the bow. 

4. Then sew the middle with a needle and thread a couple of times through all of the layers

5. After the bow is secured you'll want to cut a small piece of fabric to use as the loop for the bow. Again, see what size works best for you by testing it around the bow.

6. Once you have the appropriate size go ahead and sew it shut in a circular form. Make sure there is enough room to pull the bow through. It isn't pictured, but you will want to flatten out one side of the bow and pull it through the ring. 

7. Next stick your hair clip or bowtie clip in and you can use a little fabric glue to keep it in place. 

8. All done! 

No comments:

Post a Comment

Images by Freepik